A very easy power mod

For questions, articles, and discussions regarding water blaster modifications.
Post Reply
soakernerd
Posts: 131
Joined: Thu Mar 04, 2010 9:13 pm

A very easy power mod

Post by soakernerd » Sat Mar 19, 2011 1:22 pm

I have discovered an extremely easy mod to increase the flow through a ball valve. Drill the hole in the valve larger. I have only tested this on my Vindicator's valve, which can handle at least a 1/4" hole. The Vindicator has been in pieces, and I lost most of them, so I cannot range test for improvements. The valve still seals perfectly, as far as I can tell.
If you have a Vindicator or Vanquisher, this might be a pretty good idea.

Post Reply

Who is online

Users browsing this forum: No registered users and 33 guests