WaterWar.net

Posted: **Sun Aug 28, 2005 11:04 am**

I was wondering if I could cut off/seal the pressure gauge piping. Would this increase range or power? Would it decrease pumps needed to pressurize. I've found that after CVF'ing and XPS'ing my MD 6000 it likes to pop the pressure gauge out of the piping, cause air and water to coming flying out, and at a high pressure too...

Posted: **Sun Aug 28, 2005 1:46 pm**

Yeah, I had the same problem. You can just seal it off like you would do a CVF and it works fine.

Posted: **Sun Aug 28, 2005 1:52 pm**

Ok, thanks. I didn't know if it was a good idea or not. I guess I'll cut it off at the base, and seal it. Thanks.

WaterWar.net

XPS MD 6000 Need help with Pressure Gauge - I was wondering if...