WaterWar.net

Hello everybody! I have taken the brass nozzle off of my CPS 1200 and replaced my CPS 1700's nozzle selector with it. However my 1700 has no pump shaft because it is in my CPS 1500 which was missing one when I got it. So does anyone here have a spare one I could buy/trade for?

I have a broken 1700 (not sure which mark, but it has snap-on pump and nozzle caps) that I could just haul over wholesale. I'd probably keep the bladder at most.

How much would it cost for just the pump assembly

I'll sell it for $10 + S&H. I'll try to get some pictures of it posted shortly.

I can also deliver it at Soakemore, and shipping would be free for that.

I'm sorry but I'm not gonna make it to a war anytime soon. You do know I'm in California right? But 10 bucks doesn't sound bad so I'll think about it and also I'll need my parents help so it might be a while

Can you specify where you'd want the system cut? I'm assuming it's going to be somewhere along the tube (probably just removing it from the tube itself), but want to be sure.

Here are the photos. Click for full res.





I should also mention that you may be able to rebuild the pump/check valve system from scratch with small check valves and other components, but it'd be a hassle, there's no PRV, and it's not as guaranteed to work.

meh ill just take the shaft then. hows 7 bucks?

$7 bucks it is. I'm sending the whole check valves/PRV/pump shaft part that goes before the tube and after the reservoir because I've never seen a pump shaft separated from the rest of that assembly, and I'm too lazy to saw it down.

As for the rest of the blaster, everything works except for the pull valve (which leaks and is stuck, doesn't even operate) and for a few cracks along the piping to the bladder. (Which I filled with epoxy but don't trust repair for long term.) If you need more of the blaster for spare parts, etc. let me know. I'm primarily interested in keeping just the bladder and its case; the rest is not as useful for me.