Posted: Thu Dec 08, 2005 9:03 pm
Bought a CPS 1500 online recently and it has a couple of problems that I need some help on. Here goes:
1. This first one is kind of hard to explain, and is pump related. When I pull out the pump at a normal speed it lags really badly. I have to wait a few seconds as the valve slowly lets water into the pump shaft before I can move it again. Pump a little bit slower, and it acts normally, no lag whatsoever. There's a certain point where the mega-lag kicks in.
2. The 5x nozzle doesn't always shoot straight. Sometimes it shoots off to the left, and other times it's perfectly straight (even during the same shot).
Sorry if my first problem didn't make sense, it was hard to describe it properly. Any help or comments would be appreciated. Thanks!
1. This first one is kind of hard to explain, and is pump related. When I pull out the pump at a normal speed it lags really badly. I have to wait a few seconds as the valve slowly lets water into the pump shaft before I can move it again. Pump a little bit slower, and it acts normally, no lag whatsoever. There's a certain point where the mega-lag kicks in.
2. The 5x nozzle doesn't always shoot straight. Sometimes it shoots off to the left, and other times it's perfectly straight (even during the same shot).
Sorry if my first problem didn't make sense, it was hard to describe it properly. Any help or comments would be appreciated. Thanks!