Page 1 of 1
Posted: Wed Aug 09, 2006 10:14 am
by Dr. D
Up until yesterday, I had one remaining CPS 2100 in working condition among the seven that I've owned at various times: keyword had. Yesterday, my friend and I were doing some training excercises for two new members who just entered the league, and one was using my 2100 when the pump all of a sudden snapped off in his hand. This is the second time its happened to that particular gun. The first time it broke, I had a stockpile of spare 2100 parts that I was mixing and matching to various guns. Now I'm all out of spares. The problem is that the plastic tube-esque thing holdinh the two sides of the pump together through the pumping mechanism broke off. Can anyone think of any creative ways to remedy my problem?
Posted: Wed Aug 09, 2006 10:49 am
by Adrian
The attachment point between the two halves of the pump broke?
When this happened on my CPS 2000, I used a nail/screw and a copious amount of JBWeld. Worked pretty good too. Just remember to use JB on one side only, otherwise you can't get the pump apart again. Ever. Without a hacksaw.
Adrian
Posted: Wed Aug 09, 2006 10:53 am
by SSCBen
Adrian has it right.
This was on the website anyway: http://www.isoaker.com/Info/article.cfm ... ir_cps2000
Really easy repair. I actually did this to my CPS 2100 before it could break simply because it is much stronger. This is a repair I definitely would recommend.
Posted: Wed Aug 09, 2006 2:02 pm
by DX
I do these as a mod rather than a repair. Better safe than sorry, and better at home than during the middle of a battle. :p