Page 1 of 1

Super Soaker 50 Joint

Posted: Fri Jul 08, 2016 9:49 am
by virtualet
Hi

I have an old school SS 50 and after opening up the gun, there is a broken joint that's between the pump action and the opening into the reservoir. I assume simply super glueing this together won't suffice so wanted to see what my options were to make this thing work again. Any thoughts?

Re: Super Soaker 50 Joint

Posted: Fri Jul 08, 2016 11:08 am
by TheSoaker
You could try some epoxy putty. That should do it.

Re: Super Soaker 50 Joint

Posted: Fri Jul 08, 2016 1:18 pm
by SEAL
Hi, welcome to the board. I use something called JB Water Weld for stuff like this. It's a kind of epoxy putty, like TheSoaker mentioned. It's very strong and it holds pressure. Just don't put too much on or else the casing won't go together properly.