CPS 3000 gun doesn't hold pressure
-
- Posts: 9
- Joined: Sun May 29, 2011 1:49 pm
CPS 3000 gun doesn't hold pressure
Already after one pump the cps 3000 blaster releases its water. It's impossible to pressurise the pc. I didn't open it yet. Any tips where to start?
Re: CPS 3000 gun doesn't hold pressure
Try the rubber band repair found here.
DX wrote:In the neanderthal days of K-modding, people would lop off the whole PRV
Beware the PurpleWell, not that much soakage.
-
- Posts: 9
- Joined: Sun May 29, 2011 1:49 pm
Re: CPS 3000 gun doesn't hold pressure
Thx, I'll get into this asap.
Re: CPS 3000 gun doesn't hold pressure
Hope it works.
DX wrote:In the neanderthal days of K-modding, people would lop off the whole PRV
Beware the PurpleWell, not that much soakage.
- martianshark
- Posts: 1026
- Joined: Mon Mar 08, 2010 11:32 pm
- Location: Mars, CA
Re: CPS 3000 gun doesn't hold pressure
The rubber band mod is almost certainly what you should do. It's a really simple mod, and afterwards it will never happen again. Good luck.
CA99 wrote:It's funny because you can get 5 water bottles and a pencil for much less than $90.
Re: CPS 3000 gun doesn't hold pressure
Well, the rubber band - repair is a quick repair but will not last for a long period of time, may a summer long. Rubber outworns and dries out quite fast and then it snappes.
Best thing you can do is to open the gun's internal chamber, replace the snapped or very weak spring and put all together. THis will fix it as long as the original spring held, so about 10 years, haha
This would be a job for winter season, when no real soak-battle can be made^^ I do not use "rubber-band-repair", I always replace the spring and get it working for some years again. Opening the chamber is a little more work(some more screws...) but will fix the problem, if you use rubber band, you will have to open it again sometime soon...
Everybody it's thing, Apart this rubber band is a good thing to repair quickly and well^^
Best thing you can do is to open the gun's internal chamber, replace the snapped or very weak spring and put all together. THis will fix it as long as the original spring held, so about 10 years, haha
This would be a job for winter season, when no real soak-battle can be made^^ I do not use "rubber-band-repair", I always replace the spring and get it working for some years again. Opening the chamber is a little more work(some more screws...) but will fix the problem, if you use rubber band, you will have to open it again sometime soon...
Everybody it's thing, Apart this rubber band is a good thing to repair quickly and well^^
-
- Posts: 9
- Joined: Sun May 29, 2011 1:49 pm
Re: CPS 3000 gun doesn't hold pressure
Gun works again. Thx for the perfect solution. It was the small rubber ring inside that had come loose.
Who is online
Users browsing this forum: No registered users and 30 guests